Power Supply; Sensor Coils; Power Sensor Cabling Diagram; Power Sensor Kit - GE AK-2-50 Maintenance Manual

5. ~eplace
i°:
reverse order.
. 6.
Check positive trip to obtain approx. 1/32"
,-,vertravel after armature is moved sufficiently
to trip the breaker.
!Power Supply (F~g. 34) .
1.
Remove trip
solenoid wires from the term-
inal board on Power Supply. · ·
I
2.
Remove three boltsholdingmountingbrack-
et to mech~sm frame.
3, Remove w~ring cleats
4. Remove disconnect plug by alternately
loosening two retaining screws.
5. Remove· Power Supply Unit with control
wiring.
6. Reassemble in reverse order.
SENSOR Coils (AK-3-50) Only_ (Fig.
32)
1.
Disconnect J_>lug between the Power Supply
Unit and the sensor coils
and
rempve tapped
screw holding female plug
to
breaker mechanism
frame •
. 2. Separate front frame from back frame
as
described under SEPARATION OF FRONT
&
REAR
FRAMES.
:.
Fit;. 38. (7612-6-2) Grow1d Sensor Coil
(Remotely Located)
1. Terminal
2. External Ground Sensor Con
3. White Polarity Dot
Low Voltage Power Circuit Breakers GEK-7303
Fig. 37 (0133C9018} Power Sensor Cabling
Diagram ·
Fig. 39 (8039962) Power Sensor Kit