®
ABB i-bus
KNX
Parameters
7
Parameters
7.1
General
ETS Engineering Tool Software is used to parametrize the device.
In ETS, the applications are in the Catalogs window under Manufacturers/ABB/Heating, ventilation,
air conditioning/ Valve drive controller.
The following chapters describe the device parameters based on the parameter windows. Parameter
windows are structured dynamically so that further parameters are enabled depending on the
parametrization and function of the outputs.
The default values of the parameters are underlined, e.g.:
Options: No
The applications for devices with manual operation were used as examples for the screen shots.
This is a four-channel device. Because all channels have the same function, the function is described
based on channel A as an example.
38 2CDC508220D0211 Rev. A | VC/S 4.x.1
Note
Note