Uninstalling patch images
Perform this task in user view.
Task
Deactivate patch
images.
Aborting a software activate/deactivate operation
This task is available only for service upgrade or file upgrade performed through activate or deactivate
operation. After the operation is aborted, the system runs with the software images that it was running
with before the operation.
Task
Abort a software activate/deactivate
operation.
Committing software changes
If the ISSU method is service upgrade or file upgrade for an activate or deactivate operation, the main
startup image list does not update with the changes. The software changes are lost at reboot. For the
changes to take effect after a reboot, you must commit the changes.
Perform this task in user view.
Task
Commit the software changes.
Verifying software images
Perform this task to verify the following items:
Integrity—Verify that the boot, system, and feature images are integral.
•
Consistency—Verify that the same active images are running across the entire system.
•
Software commit status—Verify that the active images are committed as needed.
•
Command
•
In standalone mode:
install deactivate patch filename slot
slot-number
•
In IRF mode:
install deactivate patch filename chassis
chassis-number slot slot-number
Command
•
•
Command
install commit
Method 1: Press Ctrl+C while a software image is being
activated or deactivated.
Method 2: Abort a software activate/deactivate operation in
user view.
install abort [ job-id ]
143
Remarks
To deactivate patch images on a
PEX, perform the following tasks:
•
Specify its virtual chassis
number for the
chassis-number argument.
•
Specify its virtual slot
number for the slot-number
argument. The slot number is
fixed at 0 for the PEX.
Remarks
This command commits all
software changes, including
software changes for PEXs.