Table of Contents
Advertisement
Description of functions
QCU Home Address
•
•
QCU Standby Address
•
•
QDC Server
•
•
QoS L2/L3
•
•
•
•
QoS Protocol Version
•
RAM Test
•
•
Report Interval
•
•
•
•
Enter the
IP address of the QCU-Server on which the QoS-Data have
to be reported.
Standard value
page 96.
page 54
Only available when using a second communication platform.
Enter the
IP address of the QCU-Server on which the QoS-Data have
to be reported during emergency mode.
page 54
Enter the
Port-Number for communication with the QDC-Server.
Standard value
page 96.
page 56
The settings relate to the
QoS, that regulate the prioritisation of the transferred data.
For Layer 2, the
changed. For Layer 3, the
The activation of Layer 2 and / or Layer 3 support is meaningful only if
the used
Switch can interpret this information (e.g., "Layer 2
Switch").
Standard value
page 96.
page 23
page 53
The Version Number gives information regarding the actuality of the
QoS report file (read only).
page 54
Here you can test the
The results are displayed after the test is over.
page 26
page 49
Time interval (in sec.) in reports are sent.
For each Report Interval a QoS report will be sent if the
Mode was set accordingly.
Valid values: 10 ... 3600.
Standard value
page 96.
page 54
Layer 2 and
VLAN Method and the
L2/L3 Voice/Signalling can be changed.
RAM memory of your optiPoint 410/420.
Alphabetical Reference
Layer 3 areas of the
Default VLAN ID can be
Report
75
Advertisement
Table of Contents
