Siemens 2000 Administration Manual page 61

Description of functions
Compression
•
•
Compressing Codec Threshold Values
•
•
•
•
Daylight saving
•
•
Debug Interface
•
•
Chose the compression mode which has to be used, if
Band" was selected (
Standard value page 96.
page 49
Packed Codec
Lost packet thresholds [in Promille]: Packets which got lost for voice
decoding. This value is the proportion from lost packets to total number
of packets.
– Valid values: 1 ... 255
– Standard value
Consecutive lost packets [in Packets]: the lost packets in serial be-
tween two good packets will be counted. If the amount of the counted
packets is higher than the entered value the threshold will be exceed-
ed.
– Valid values: 1 ... 255
– Standard value
Consecutive good packets (aufeinanderfolgend verarbeitete Pakete [in
Paketen]): the good packets in serial between two bad packets will be
counted. If the amount of the counted packets is lower than the en-
tered value the threshold will be exceeded.
– Valid values: 1 ... 255
– Standard value
page 54
This entry is only required if you selected "SNTP" in the
field.
Activate this field if you want the clock on your telephone to automati-
cally switch between daylight saving and standard time.
page 57
Only necessary for development. However, this function can be used
for debugging customer systems in an emergency.
If this field is activated, the WindRiver Tornado debugger contacts the
telephone and allows the software to be debugged.
page 56
G.723 oder G.729).
page 96.
page 96.
page 96.
Alphabetical Reference
Codec „Lo-
Time Source
61