Automatic Deactivation Of Pdp Context During Dial-Up Ppp - Siemens Brodersen MC55 AT Command Manual

Notes
• If the MT is in dedicated mode, write command returns "+CME ERROR: operation temporary not allowed".
• It is possible to leave the GPRS data mode and enter the command mode by using the V.250 command +++.
By using the command
data mode, depends on the supplied parameter <cid>.
If no is specified, this is equivalent to using the V.250 command ATO, which is usable for GPRS con-
<cid>
nections too. In this case the first context will be used, which is active and already in data mode since it has
been activated (the internal context used for GPRS connection without explicitly specifiying a context identi-
fier has the highest priority).
It is possible to use
AT+CGDATA
has been activated. With
11.6.1

Automatic deactivation of PDP context during dial-up PPP

When using the AT+CGDATA write command or
code CONNECT and enters V.250ter online data state. In V.250 online data state, first some LCP protocol
exchange between MT and TE is performed to set up the PPP link. After successfully establishing the PPP link,
the MT performs the PDP context activation procedure if the context is not already activated. As a result, the MT
is in a "PDP context activated" state within the PLMN, the PPP link is established on the mobile side and the
mobile is ready for IP data transfer.
If the TE wants to close the LCP link the MT may perform an LCP termination request procedure on PPP level.
After this LCP termination procedure the MT deactivates the PDP context automatically and the MT returns to
V.250 command mode and issues the final result code NO CARRIER.
During the implicit PDP context deactivation procedure after LCP termination the TE may change into V.250
command state (e.g. by using
In this case the application should not try to deactivate the PDP context by using the commands
ATH. If DTR is configured to disconnect data connections (AT&D2), then the application should not toggle DTR
during the implicit PDP context deactivation and before "NO CARRIER" is received.
MC55_ATC_V04.00
Confidential / Released
again, the data mode is reentered. Which context is used to return to
AT+CGDATA
to enter the data mode for a context, which is not yet in data mode since it
this is not possible.
ATO
ATD*99#
or by toggling DTR if
+++
Page 276 of 475
or the MT issues the intermediate result
ATD*98#
is set to 1) before the result NO CARRIER occurs.
AT&D
or
AT+CGACT
3/17/06