At^sops Extended Operator Selection - Siemens Brodersen MC55 AT Command Manual

8.3

AT^SOPS Extended Operator Selection

queries the present status of the MC55's network registration. Since basic operator selection services
AT^SOPS
are available with
AT+COPS
specification while handling operator name strings. Additional
AT^SIND.
test command lists sets of five parameters, each representing an operator present in the network.
AT^SOPS
A set consists of
an integer indicating the availability of the operator,
1.
specification of the source of the operator name <eonsOperator>,
2.
operator name according to EONS Table,
3.
Service Provider Name from the SIM Service Table and
4.
numeric format representation of the operator.
5.
Any of the parameters may be unavailable and will then be an empty field (,,).
The list of operators comes in the following order: Home network, networks referenced in SIM and other net-
works.
After the operator list the MC55 returns lists of supported <mode>s and <format>s. These lists are delimited
from the operator list by two commas.
If the test command is used while an ongoing GPRS transfer, traffic will be interrupted for up to one minute.
Command settings are effective over all serial interfaces of the MC55.
Syntax
Test Command
AT^SOPS=?
Response(s)
^SOPS:[list of present operator( <opStatus>, <eonsType>, <eonsOperator>, <servProvider>,
<opName>)s ], , (list of supported <mode>)s, (list of supported <format>)s
OK
ERROR
+CME ERROR: <err>
Reference(s)
SIEMENS
Parameter Description
(num)
<opStatus>
Status
0
1
2
3
(num)
<eonsType>
Specification of the source of the operator name <eonsOperator>. Details of
types are available at AT^SIND.
MC55_ATC_V04.00
Confidential / Released
this command uses the methods of the Enhanced Operator Name String (EONS)
unknown
operator available
current operator
operator forbidden
Page 166 of 475
EONS related information
PIN ASC0 ASC1 MUX1
% % % %
is available with
MUX2 MUX3 Charge
% % ! !
EONS-supplied operator name
Last
!
3/17/06