Canon Inner Finisher-A1 Service Manual page 80

9) Joint the supplied relay harness to the connectors of the finisher controller PCB and
the additional tray driver PCB.
x2
11) Put the upper guide as shown in the figure paying attentionto the safety switch sensor unit.
Then fix it with 6 screws. (Stepped screw x 2, Binding screw x 4)
MEMO:
Confirm that the harness fixed at the step 10) does not come out of the upper guide.
Stepped screw
6
Installation(Addtional Tray-A1) > Installation Procedure > Connecting to Connected Equipment
F-6-15 F-6-15
6 Installation(Addtional Tray-A1) > Installation Procedure > Connecting to Connected Equipment
10) Fix the inner front cover removed in Step 5 with the 3 screws.
x3
12) Fix the screw to secure the safety switch sensor unit.
x6
F-6-17 F-6-17
x1
6-9
F-6-16 F-6-16
F-6-18 F-6-18
6-9