Canon Inner Finisher-A1 Service Manual page 67

5
Installation(Inner Finisher-A1) > Installation Procedure > Installation Procedure
16) Remove the sensor flag of the 2nd delivery tray. The sensor flag is no longer reused.
(This step is applicable only when the 2nd delivery tray is installed in the host machine.)
MEMO: Bend the sensor flag shaft a little to remove it.
18) Remove 2 screws to detach the control panel lower cover.
The lower cover is no longer reused.
x2
5 Installation(Inner Finisher-A1) > Installation Procedure > Installation Procedure
17) Remove 1 screw to detach the small cover. Reverse the small cover and restore it to the original position. Removed
1
2
F-5-20 F-5-20
19) Remove 1 screw and detach the protection cover at delivery part by shifting it to the front side.
Remove the paper placed at the step 9).
The protection cover is no longer reused.
F-5-22 F-5-22
screw is no longer reused for the installation.
(This step is applicable only when the 2nd delivery tray is installed in the host machine.)
MEMO:The removed screw is no longer reused.
x1
5-9
F-5-21 F-5-21
F-5-23 F-5-23
5-9