Removing The Gripper Open/Close Motor; Removing The Stp Move Motor/Gripper Unit Move Motor - Canon Inner Finisher-A1 Service Manual

4
Parts Replacement and Cleaning Procedure > Removing the Motors > Removing the STP Move Motor/Gripper Unit Move Motor

Removing the Gripper Open/Close Motor

1) Remove the gripper unit.
"Removing the Gripper Unit"(page 4-7).
2) Remove one screw and then the cover.
3) Remove one connector and then the harness from the harness guide.
x1

Removing the STP Move Motor/Gripper Unit Move Motor

1) Remove the upper unit.
"Removing the Upper Unit"(page 4-4).
2) Move the stapler rearward.
4 Parts Replacement and Cleaning Procedure > Removing the Motors > Removing the STP Move Motor/Gripper Unit Move Motor
4) Remove two screws and then the gripper open/close motor.
F-4-59 F-4-59
3) Remove the reuse band of the additional tray harness (only when the additional tray is installed).
4) Remove the reuse and of the tray harness.
5) Remove two screws.
F-4-61 F-4-61
x2
x2 x1
4-22
F-4-60 F-4-60
F-4-62 F-4-62
4-22