Table of Contents
Advertisement
6.17
USER VALUES
This 'Toolkit' option block allows up to 12 values to be configured for use as inputs to other parameters.
6.17.1 Parameters
Units
Resolution
High/Low Limit
Value
Status
6.18
ALARM SUMMARY
Allows the user to view the overall status of the unit's alarms, and to carry out a global acknowledgement of
active alarms if required.
Global Ack
Any Channel alarm Indicates if there are any channel alarms active, acknowledged etc.
Any Sys Alarm
Any Alarm
6.19
REAL TIME EVENT CONFIGURATION
This allows the user to configure up to two events to trigger at a specific time and date, or on a particular day,
and to remain active for a configurable time, either measured as a duration, or as a specific 'Off' time.
Typical applications would be to start and/or stop a programmer at a particular time, or to act as an input to a
'Wait' segment.
September 18
FEC920: USER GUIDE
Resolution
High Limit
Low Limit
Figure 104 User value configuration
Allows a five-character string to be entered for the user value units.
The number of decimal places for the user value (max. = 6).
Sets maximum and minimum values to which the User value can be set.
The user value, either entered manually, or wired to another appropriate parameter.
The output status for the User Value.
Allows the user to acknowledge all applicable alarms simultaneously. 'Manual' alarms
must be non-active before they can be acknowledged.
Indicates if there are any active system alarms.
Indicates if there are any channel or system alarms active.
Alarm Summary.Global
Global Ack
Any Channel Alarm
Any Sys Alarm
Any Alarm
Figure 105 Alarm summary display
A5E45696052A Rev-AA
User Value.1
Units
2
100000000.00
-100000000.00
Value
0.00
Status
Ok
No
Yes NAck
Yes
Yes
Page 113
Advertisement
Table of Contents
