ABB i-bus KNX Product Manual page 54

®
ABB i-bus KNX
Commissioning
Name
Options:
Every lighting group can be assigned with a name consisting of a maximum of 40 characters.
The name is stored in the ETS database and also stored in the DGN/S by a download. In this way, the
name is also available in the DALI-Software-Tool.
A uniquely universal designation simplifies the description of the engineering project.
Select additional function
Options:
This parameter defines an additional function for this lighting group.
none: This lighting group operates as a "normal" group of the group-orientated DGN/S without addi-
tional function.
Slave: This lighting group is defined as a slave. This slave lighting group is forcibly operated by a mas-
ter. This could be, e.g. an ABB i-bus
page 68, is enabled. In these windows, the properties for the slave lighting group are parameterized.
The required brightness value is received via the communication object Brightness value of slave from
a master.
Sequence: The lighting group uses the function Sequence. In sequence operation, up to ten light sce-
nes are automatically run off consecutively. You program how often the sequence compilations are to
be repeated. With the function Sequence, programming of running lights and colour effects or bright-
ness transitions without additional logic or timer modules is possible. Together with the function Se-
quence, the
reaction of the lighting group during a sequence recall is set. The sequence operation, which applies
for the entire DGN/S, is parameterized in
window is enabled if the
time curve (one curve per gateway), has been parameterized with yes.
Staircase lighting: With activated function Staircase lighting, the lighting group is switched on, and af-
ter a defined time it is automatically switched off or dimmed down slowly as a warning. The basis
brightness is the brightness, to which the lighting group is set after the staircase lighting time has
elapsed. This basis lighting time may also be not equal to zero.
Example
This function can ensure, e.g. that a basis brightness level always exists in the hallways in nursing
homes or hospitals. Maximum brightness is only activated when someone enters the hallway
(detected by a presence detector). It is dimmed down automatically to the basis brightness, after
the staircase lighting time has timed out and when nobody is in the hallway.
The setting of a warning before the function Staircase lighting switches off is possible using dimming
down.
52 2CDC 507 114 D0201 | DGN/S 1.16.1
Gx
none
Slave
Sequence
Staircase lighting
®
Light Controller LR/S x.16.1. The
Parameter window - Gx Sequence
Parameter window General
on page 74 is enabled. In this parameter window, the
Parameter window Sequence
on page 27 and the parameter Enable sequence
Parameter window - Gx Slave,
on page 87. This parameter