ABB i-bus KNX Product Manual page 19

®
ABB i-bus KNX
Device Technology
Supplied state
The device is supplied with the physical address 15.15.255. The application program is preloaded. It is
therefore only necessary to load group addresses and parameters during commissioning.
However, the complete application program can be reloaded if required. A longer downtime may result if
the application program is changed or after a discharge.
Assignment of the physical address
The assignment and programming of the physical address is carried out in the ETS.
The device features a
after the button has been pushed. It switches off as soon as the ETS has assigned the physical address or
the
Download response
Depending on the PC, which is used, the progress bar for the download may take up to one and a half mi-
nutes, before it appears, due to the complexity of the device.
Cleaning
If devices become dirty, they can be cleaned using a dry cloth or a cloth dampened with a soapy solution.
Corrosive agents or solutions should never be used.
Maintenance
The device is maintenance-free. No repairs should be carried out by unauthorised personnel if damage
occurs, e.g. during transport and/or storage.
button for assignment of the physical device address. The red LED
button is pressed again.
lights up,
DGN/S 1.16.1 | 2CDC 507 114 D0201 17