Motorola SC 4812ET RF Hardware Installation Manual page 182

Installing RF GPS
– continued
Installation Procedure
Step
1 Determine the mounting location (see RF GPS Mounting Considerations in this chapter).
2 Install the mounting kit at the RF GPS location of choice. Use the appropriate mounting bolts for
mounting surface.
n WARNING n WARNING
The roof structure on which the mounting pole is attached should be verified by a qualified structural
engineer for the weight of the RF GPS engine and mounting hardware or under adverse conditions for
the installation area
! CAUTION
Mounting the RF GPS antenna and hardware to an inadequate roof surface and/or using inadequate
installation methods can result in serious injury.
3 Attach the RF GPS head assembly to the post mounting assembly and secure the assembly to the
assembly to the Mounting kit using the screws and nuts supplied (see Figure H-1).
4 Attach the Grounding Kit to the mounting pole.
5 Connect one (1) N connector of the 50–feet superflex cable to the N jack of the RF GPS antenna cable
and route the other end of the cable down to the RF cabinet.
6 Install the cable into the DC I/O area through the conduit I/O plate and via rubber I/O boot. The RF
GPS I/O connection for the cable is listed in Chapter 5.
H
182
Table H-1 lists the step of installing the RF GPS system.
Table H-1: Installing the RF GPS
SC 4812ET RF and Power Cabinet Hardware Installation Manual
TM
Action
DRAFT
Apr 2001
V0H.01