5-2
5.3
Routine Maintenance
Absolute cleanliness of the work area, tools and equipment are essential.
Replacing the output connector o-ring
After inspection as detailed in maintenance task B, carry out the following if the o-ring is worn or
damaged:
1. Carefully remove the o-ring from the small groove at the top of the connector. Fit a new o-ring in
the small groove at the top of the connector.
2. Make sure the o-ring is tight in the groove and not damaged after fitting.
Note: Damage to this o-ring causes leaks.
Replacing a fuse
1. Disconnect the electrical power supply.
2. Unscrew the fuse holder cap and remove the fuse.
3. Only fit a new fuse of the correct type and rating into the fuse holder cap.
4. Secure the fuse holder in the front panel.
5.4
Battery care and maintenance
ADTS Touch battery pack
The battery unit contains a Lithium Ion battery which requires no user maintenance.
Prolonged exposure to temperature extremes may significantly reduce battery lifetime. For
maximum lifetime, avoid prolonged periods where the battery is exposed to temperatures outside
the range -30°C to +45°C.
The recommended storage temperature range is 5°C to 21°C (41°F to 98.8°F).
ADTS542F/552F/553F/554F User Manual
Figure 5-1 Replacing the o-ring
o-ring
K0553 Revision C