Accessories Supplied - HP 11848A Service Manual

Model 11848A
General Information
ACCESSORIES SUPPLIED
The accessories supplied are pieces of equipment that are shipped with every Interface. The accessories
are shown in Figure 1.
Line Power Cable. The line power cable may be supplied in several plug configurations, depending
on the destination of the original shipment. Refer to Power Cables in the Installation section of this
Service manual.
Fuses. Puses with a 0.75A rating for 115 Vac (HP part number 2110-0063) and a 0.5A rating for 230
Vac (HP part number 2110.-0012) are supplied. One fiise is factory installed according to the voltage
available in the country of original destination. Refer to Power Requirements in thfe Installation of this
Service manual.
HP 3048A Software Discs and Manual Set. The H P 3048A software set and associated manuals are
shipped with the Interface.
HP 3048A Software Set (HP part number 11848-61026).
HP 11848A Service Manual (HP part number 11848-90004).
HP 3048A Operating Manual (HP part number 03048-90001).
HP 3048A Reference Manual (HP part number 03048-90002).
50Q Termination. This 50Q load is used to terminate the Interface's Spectrum Analyzer output if no
RF spectrum analyzer is available (HP part number 1250-0207).
Adapters, Type-N to BNC. Three adapters are provided for system operation (HP part number
1250-0780).
Cable Assemblies: BNC. Two 30 cm (12 in.) cables are provided for system operation (HP part
number 8120-1838).
Noise Floor Test Fixture. This test fixture is used to run performance tests (HP part number
11848-61032).
Cable Assembly: BNC to SMB. This cable assembly can be used during troubleshooting (HP part
number 08954-60105).
5