Table of Contents
Advertisement
Model 35601A
Installation
250 V
OPERATION
PLUG-:CEE7-V11
CABLE*: HP 8120-1692
X
PLUG* :NEMA 1-15P
CABLE*: HP 8120-0684
2 5 0 V
OPERATION
PLUG*: CEE22-V1
CABLE*: HP 8120-1860
250 V
OPERATION
PLUG*: NZSS 198/AS C112
CABLE*: HP 8120-0696
STD-B-4195(Rev.)
250 V
OPERATION
PLUG*: DHCR 107
CABLE*: HP 8120-2956
2 5 0 V
OPERATION
PLUG'iBS 1363A
CABLE*: HP 8120-1703
250 V
OPERATION
PLUG*: SEV 1011.1959-24507
TYPE 12
CABLE*: HP 8120-2104
PLUG*:NEMAG-1SP
CABLE*: HP 8120-0698
PLUG*: NEMA 5-15P
CABLE*: HP 8120-1521
•The number shown for the plug is the industry identifier for the plug only.
The number shown for the cable is an HP part number for a complete cable including the plug.
* *UL feted for use in the United States of America
Figure 2-5. Power Cables
2-9. Power Cable Connection
The -hp- 35601A was installed into the -hp- 3047A using a three-wire power cord (-hp- part
number 8120-2307). This is the type of cable that should be used to supply power to the in
strument while it is installed in the -hp- 3047A, regardless of power line voltage and frequen
cy. If, for some reason, the instrument is to be operated out of the system, then use the ap
propriate power cable from the ones shown in Figure 2-5.
With the front panel power switch in the OFF position, connect the ac power cable to the
rear panel LINE connector. Plug the other end of the power cable into the three-terminal
grounded power strip in the system cabinet.
To protect operating personnel, the -hp- 35601A chassis and
cabinet must be grounded. The -hp- 35601A is equipped with a
three-wire power cord which, when plugged into an appropriate
receptacle, grounds the instrument. The offset pin on the power
plug is the ground connection. To preserve this protection feature,
the power plug shall only be inserted in a three-terminal receptacle
having a protective earth ground contact. The protective action
must not be negated by the use of an extension cord or adapter
that does not have the required earth ground connection. Ground-
ing one conductor of the two-conductor outlet is not sufficient
protection.
2-5
Advertisement
Table of Contents
