Siemens Cerberus CS1140 Manual page 145

Building Technologies
Fire Safety & Security Products
3 Programming switch "S3": "I-Bus address" setting
Each element (module) connected to I-Bus must have an individual address (number).
This is set on programming switch "S3".
Maximum 16 I-Bus devices.
Function / I-Bus address
Nr.
0 Module out of commission (unused)
1 I-Bus user number 1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
"S3-1...6" are set to "off" at the factory
4 Flachband-Header "ST1" (26-polig): I-Bus
0 Ω resistor: no function (factory setting X11)
5
6 Maintenance switch "S2": To switch on maintenance LEDs for test purposes.
In addition to the control line, it also enables the activation of the correspond-
ing LED (H1...H6).
S2-on = LED (H1..H6) lights if the control line is activated.
7 Plug-in terminals "K2": to synchronize Horns or external oscillator input
8 Plug-in terminals "K1": Supply for "I-Bus" modules
9 Plug-in terminals "K3": External horn supply
10 Fuse: 'F19' 6.3 A/T for internal module and horn if internal supply (K1)
0 Ω resistor: Supply for 6 horn outputs (X1-2..14)
11
X12 = internal supply (factory setting) (K1)
Y12 = external supply (K3)
12 Fuses: 'F1, F3, F5, F7, F9, F11' 2 A/T Control lines monitored (Fuses with
high breaking capacity, sand-filled)
13 Test LEDs 'H1...H6' at rear allocation of the individual LEDs H1...H6 –> see
page 146
E3G060 Control module "monitored" (Part No 542539)
S3-1 S3-2
off
on
2 off
3 on
4 off
5 on
6 off
7 on
8 off
9 on
10 off
11 on
12 off
13 on
14 off
15 on
16 off
Programming switch S3
S3-3 S3-4 S3-5
off off off off
off off off off
on off off off
on off off off
off on off off
off on off off
on on off off
on on off off
off off on off
off off on off
on off on off
on off on off
off on on off
off on on off
on on on off
on on on off
off off off on
001260_k_en_--.doc
S3-6
off
off
off
off
off
off
off
off
off
off
off
off
off
off
off
off
off
145
02.2005