Start-Up; Overview - ABB i-bus KNX Product Manual


ABB i-bus KNX

Start-up

3 Start-up
The central functions of the blind/roller shutter actuators are described in this section. The
parameterization of the blind/roller shutter actuator is implemented with the application program and the
Engineering Tool Software ETS. Using the application program, a comprehensive and flexible range of
functions are available to the device. The standard settings allow simple commissioning. The functions can
be extended if required.
The application program can be found at ABB/Blind/Switch.
For parameterization purposes, a PC or Laptop with ETS and a connection to the KNX, e.g. USB or IP
interface, is required.
3.1

Overview

Overview of the functions in a tabular form.
JRA/S characteristics
Hardware
Number of Outputs
Nominal voltage
Installation type
Module width (in space units)
 = Characteristic applies
General parameterization options
Manual functions
Disable/enable manual operation
Status Manual operation
Operating modes
Control with slat adjustment (blind etc.)
Control without slat adjustment
(shutters, awning, etc.)
Ventilation flaps, switch mode
General device functions
Automatic travel detection
Time-delayed switching of drives
Limit rate of telegrams
Transmission and switching delay
In operation function
Request status values
Ventilation flaps, switch mode
Extended setting options for drives and
blinds/shutters
Continued overleaf
X.230.5.1 4.24.5.1
X = 2, 4, 8 4
230 V AC 24 V DC
MDRC MDRC
2-fold, 4-fold:
4 space units,
4
8-fold:
8 space units
X.230.5.1 4.24.5.1
■
■
■
■
■
■
■
■
■
■
■
■
■
X.230.2.1
X = 2, 4, 8
230 V AC
MDRC
2-fold, 4-fold:
4 space units,
8-fold:
8 space units
X.230.2.1
■ ■
■ ■
■ ■
■ ■
■ ■
■
-
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
JRA/S | 2CDC 506 051 D0204 31
X.230.1.1
X = 2, 4, 8
230 V AC
MDRC
2-fold, 4-fold:
4 space units,
8-fold:
8 space units
X.230.1.1
-
-
■
■
■
-
■
■
■
■
■
■
■