Alarm System Settings - Panasonic KX-HNB600 User Manual

Using the app
– Glass break sensors: Enabled
– Indoor camera motion detection features: Disabled
– Outdoor camera motion detection features: Enabled
Disarm
Use this mode when alarm system features are not needed.
Water leak sensors are always enabled, even when this mode is selected. All other sensors are disabled
when this mode is selected.
Confirming the current arm mode
The icons displayed near the top of the home screen indicate the current arm mode.
See "Arm mode icons", Page 33 for details.
Changing the current arm mode
Tap the icon of the desired arm mode at the top of the [Home Network] app home screen.

Alarm system settings

You can customize settings for [Arm: At Home] mode and [Arm: Away] mode to suit your needs.
1
From the [Home Network] app home screen, tap [Settings].
2
Tap [Arm Settings].
3
Select which type of settings you want to change.
– [Arm Settings (At Home)]: The settings you change will be applied when the arm mode is set to
[Arm: At Home].
– [Arm Settings (Away)]: The settings you change will be applied when the arm mode is set to
[Arm: Away].
– [Alert by Phone Call]: See "Alert by phone call", Page 47.
– [Change Arm PIN]: See "Alarm system PIN", Page 49.
4
Select the desired setting.
5
Change the settings as desired.
R Each setting is explained in this section.
6
Follow the on-screen instructions.
Enabling and disabling individual sensors
While configuring the settings for an arm mode, tap the name of the desired sensor and then select the
desired operating mode.
– [Enable]: This setting enables the selected sensor during the corresponding arm mode.
– [Enable (Entry Delay)]: This setting is the same as when [Enable] is selected, but an entry delay is
also applied. For more information, see "Entry delay time and alert volume (available for [Arm: Away]
mode and [Arm: At Home] mode)", Page 47.
– [Disable]: This setting disables the selected sensor during the corresponding arm mode.
Exit delay time and alert volume (available for [Arm: Away] mode only)
The exit delay can give you time to leave the house before the alarm system is armed. This setting
determines the amount of time.
When you change the arm mode to [Arm: Away], the exit delay begins counting down. During this time,
the alarm system cannot be triggered.
Setting the exit delay time
Tap the current time setting, select the desired time, and then tap [OK].
46