Canon FINISHER-C1 Service Manual page 177

Positive Width Adjustment
Unit: mm
EX. If L is 1 mm, provide '1mm'.
Negative Width Adjustment
Unit: mm
EX. If L is 0.75 mm, provide '0.75mm'.
Figure 6-111
9) By referring to Table 5-101 below, change
the settings of bits 6 through 8 on DIPSW1.
• If the width adjustment is '0',
The stitching position and the folding po-
sition match, requiring no change.
• If for "positive width adjustment,"
Set DIPSW1 so that the difference result-
ing from subtraction of the interval from
the appropriate setting in Table 5-101 is
provided.
For instance, if the DIPSW1 is currently
set to +2 and the interval is +1 mm, set
DIPSW1 to reflect -2.
COPYRIGHT © 1998 CANON INC.
Marking
Folding position
Stitching position
Marking
Stitching position
Folding position
FINISHER-C1/SADDLE FINISHER-C2 REV. 0 DEC. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 6 TROUBLESHOOTING
• If for "negative width adjustment,"
Set DIPSW1 so that the sum resulting from
addition of the interval to the appropriate
setting is provided.
For instance, if DIPSW1 is currently set to
-1 and the interval is +1 mm, set DIPSW1
to reflect +2.
DIPSW1 bit settings
bit 6 bit 7 bit 8
OFF ON
OFF ON OFF
OFF OFF
OFF OFF OFF
ON OFF
ON ON OFF
ON ON
Do not touch the following.
bit 6 bit 7 bit 8
ON OFF OFF
Table 6-102
10) Shift bits 1 through 4 on DIPSW1 to OFF.
2. Stitching Position (adjusting cen-
ter stitching)
Use the copier's user mode to perform the
following:
1) Press the user mode key on the copier's
control panel to start user mode.
2) Press the 'adjust/clean' key on the LCD.
3) Press the 'down' key to bring out the 2/2
screen.
4) Press 'adjust center folding position' key.
5) Press the appropriate key: 'A3, 11x17',
'B4', or 'A4R, LTRR'.
6) Enter the adjustment value in increments
of 0.25 mm by pressing the 'down' key or
the 'up' key
To stop adjustment, press the 'stop' key.
Settings
(in units of 0.25 mm)
ON +3
+2
ON +1
0
ON -1
-2
ON -3
6-5