ABB COMMANDER 1900 Series User Manual page 18

• Totalization
...4 ADVANCED CONFIGURATION LEVEL
...4.2 Set Up Totalizer
rAP
ON
OFF
rESEt
ENbL–Y
ENbL–N
rSt. S rC
EQN–4
NONE
StOPGO
ENbL–Y
ENbL–N
SG SrC
EQN–4
NONE
SELECt
tOt–x
16
Wrap On/Off
If the wrap-around facility is selected, the front panel total is automatically reset to the
once the
Value Predetermined Value
If the wrap-around facility is not selected, the front panel total stops counting when the
is reached.
Predetermined Value
Select ON to enable or OFF
Note. If a relay or digital output is assigned to the wrap facility the relay or digital output is
energized by a wrap pulse for approximately 1 second when the
A wrap pulse is always transmitted when the
Reset Enable
ENBL-Y
Select to enable or
.
OPERATOR LEVEL
Reset Source
Select the digital source required to reset the totalizer.
For description of source, refer to Table 2.1 on page 10.
Counter Stop/Go Enable
Select ENbL-Y to enable or
.
OPERATOR LEVEL
Source Stop/Go
Select the digital source required to stop or start the totalizer.
An 'active' source state starts the totalizer and an 'inactive' source stops the totalizer.
For description of source, refer to Table 2.1 on page 10.
Return to Select Totalizer frame.
is reached.
to disable.
Predetermined Value
ENAbL-N
to disable the counter reset frame in the
ENAbL-N to disable the counter Stop/Go frame in the
Preset
is reached.
Predetermined Value
is reached.
Totals Page
Totals Page
,
,