D-Link DSL-5300 User Manual page 67

Section 4 - Configuration
DTIM Interval:
The DTIM (Delivery Traffic Indication Message) interval set the wake-
up interval in power saving mode. The default and recomended
setting is 3 ms.
Beacon Interval:
The Beacon Interval is the time in milliseconds between one DTIM
and the next. Lower this for unstable connections and roaming
devices. The default and recommended setting is 100 ms.
Enable TX
Transmission Bursting improves transmission speed between the
Bursting:
router and 802.11g devices. The default and recommended setting
is Enable.
Enable WMM
Enable WMM APSD (Wi-Fi Multimedia Automatic Power Save
APSD:
Delivery) to improve power management between wireless devices.
Optimize
AMPDU (Aggregated-MAC Packet Data Unit) optimizes the number of
AMPDU
MSDUs (MAC Service Data Units) to avoid packet loss in error-prone
Aggregation:
wireless channels.
Modulation
Specifies the modulation scheme used for wireless transmission.
Scheme:
By default, wireless networks reduce speed to the slowest client. This
Aitrime
setting allocates time equally among clients, each running at their
Fairness: highest speeds. The default setting is disabled.
Multi-User
Multi-User MIMO (Multiple Input Multiple Output) allows
MIMO:
transmissions to take multiple paths using multiple antennas,
dramatically increasing throughput. The default and recommended
setting is Auto.
Explicit
Explicit Beamforming can be used when all clients support beam
Beamforming:
forming, and allows use of channel estimation and direction steering
to improve link speeds.
D-Link DSL-5300 User Manual 63