Table of Contents
Advertisement
Getting Started
Before Installing the CPV5300
2
!
Warning
Installing the CPV5300
2-2
After removing the CPV5300 from its packaging:
Check for obvious physical damage.
Verify that the coin cell battery is in its holder and inserted
correctly.
Install main memory DIMMs. Refer to Chapter 4, "Installing
Options" for information about the DIMMs and their installation.
Make sure that you disconnect the chassis from the main
power supply before you continue.
Use these steps to install the CPV5300 into your computer chassis. Refer
to Figure 2-1.
1. Follow the instructions in your chassis user manual to remove any
outer cover.
2. Locate the "system slot" (normally slot one - the far right slot when
viewed from the front).
3. Remove any filler panel (or existing CPU board) that might fill that
slot.
4. Install the top and bottom edge of the CPV5300 in the guides of the
chassis.
5. Ensure that the levers of the two injector/ejectors are in the outward
position.
6. Slide the CPV5300 into the chassis until resistance is felt.
Advertisement
Table of Contents
