Grouped Elements; Overview; Setting Group; Line Differential Elements - GE L30 Instruction Manual

5.6 GROUPED ELEMENTS

5.6GROUPED ELEMENTS
Each protection element can be assigned up to six different sets of settings according to setting group designations 1 to 6.
The performance of these elements is defined by the active setting group at a given time. Multiple setting groups allow the
user to conveniently change protection settings for different operating situations (for example, altered power system config-
uration, season of the year, etc.). The active setting group can be preset or selected via the
Control elements section later in this chapter). See also the Introduction to elements section at the beginning of this chap-
ter.
PATH: SETTINGS GROUPED ELEMENTS

SETTING GROUP 1

5
Each of the six setting group menus is identical. Setting group 1 (the default active group) automatically becomes active if
no other group is active (see the Control elements section for additional details).
a) MAIN MENU
PATH: SETTINGS GROUPED ELEMENTS
LINE DIFFERENTIAL
ELEMENTS
5-116
SETTING GROUP 1(6)
LINE DIFFERENTIAL
ELEMENTS

PHASE CURRENT

MESSAGE
NEUTRAL CURRENT
MESSAGE
GROUND CURRENT
MESSAGE
NEGATIVE SEQUENCE
MESSAGE
CURRENT
BREAKER FAILURE
MESSAGE
VOLTAGE ELEMENTS
MESSAGE
SUPERVISING
MESSAGE
ELEMENTS
SETTING GROUP 1(6)
CURRENT
DIFFERENTIAL
STUB BUS
MESSAGE
L30 Line Current Differential System
SETTING GROUPS
See page 5-116.
See page 5-121.
See page 5-131.
See page 5-133.
See page 5-136.
See page 5-138.
See page 5-146.
See page 5-153.

5.6.3 LINE DIFFERENTIAL ELEMENTS

LINE DIFFERENTIAL ELEMENTS
See page 5-117.
See page 5-120.
5 SETTINGS

5.6.1 OVERVIEW

menu (see the
5.6.2 SETTING GROUP
GE Multilin