HP 10500 Series Configuration Manual page 47

Figure 17 Dialing the number
8. After you hear the dial tone, press Enter as prompted:
If authentication is disabled, the user view prompt appears, as shown in
If password authentication is enabled, the user view prompt appears after you provide the
correct password.
If password authentication is enabled, the user view prompt appears after you provide the
correct username and password.
Figure 18 Login page when authentication is disabled
IMPORTANT:
Do not directly close the HyperTerminal. Doing so can cause some modems to stay in use, and your
subsequent dial-in attempts will always fail.
To disconnect the PC from the device, execute the appropriate ATH command in the HyperTerminal. If the
command cannot be entered, type AT+ + + and press Enter, and when the word OK appears, execute the
39
Figure 18.