Configuring The Asset Profile Of A Physical Component; Disabling Sending Removal Interrupt Signals Before Switching Fabric Module Removal - HP 10500 Series Configuration Manual

To enable the port-down function globally:
Step
1. Enter system view.
2. Enable the port-down function
globally.
Configuring the asset profile of a physical
component
You can configure an asset profile for physical components, including chassis, cards, fan trays, and
power supplies for easy management.
To configure the asset profile of a physical component:
Step
1. Enter system view.
2. Configure the asset profile of a physical
component.
NOTE:
For power supplies, you can only set their asset IDs.
Disabling sending removal interrupt signals before
switching fabric module removal
By default, a switching fabric module sends removal interrupt signals before it is removed so that the
device can switch the traffic to another switching fabric module, ensuring uninterrupted traffic.
If the switching fabric module frequently sends incorrect removal interrupt signals before it is removed, the
device might fail. To avoid this situation, configure the switch-fabric removal-signal-suppression
command.
To disable the switching fabric module from sending removal interrupt signals before it is removed:
Command
system-view
monitor handshake-timeout
disable-port
Command
system-view
•
In standalone mode:
set asset-info { chassis | fan fan-id | power power-id | slot
slot-number } { csn csn-number | custom name value |
department department | description description | location
location | service-date date | state state }
•
In IRF mode:
set asset-info chassis chassis-number { chassis | fan fan-id |
power power-id | slot slot-number } { csn csn-number |
custom name value | department department | description
description | location location | service-date date | state
state }
177
Remarks
N/A
By default, this function is
enabled.