Configuration; Additional Base Radio For Existing Module Cage In Mts 4 - Motorola DIMETRA MTS 4 Installation, Configuration, And Service Manual

Applicant: Motorola Solutions
3066553B01
3066556B02
3066545B01
12 Connect the RJ45 cable according to the scheme below:
Part no
3066544B06
13 Switch ON the Power Supply Unit.
14 Check the LED indicators to verify the PSU is operating correctly.

Configuration

No configuration in itself is needed for the module cage, but the Power Supply Unit needs to be configured and this is
described in Updating the Mapping List with the New PSU TrackID on page
Installation and configuration of additional Base Radios are described separately in
Existing Module Cage in MTS 4 on page
Furthermore, if an additional Site Controller is ordered as a separate expansion kit, it needs to be installed and
configured, see

Additional Base Radio for Existing Module Cage in MTS 4

It is possible to add a Base Radio into an existing module cage of the MTS 4.
Note: The additional Base Radio is delivered with the expansion kit that includes required equipment and
cables.
AC Power Cable
Batt Sens cable
DC Power Cable
Note: If Base Radio being added is the second Base Radio in a Module Cage (BR2 or BR4), DC Power
Cable (3066545B01) is already existing in configuration.
Cable type
RJ45 Cable
381.
Redundant Site Controller on page
Equipment Type: ABZ89FC5827 / 109AB-5827
Junction panel / AC In 2
Junction panel / Bat Temp 2
BR3 / DC In
BR4 / DC In
Site Controller / Power
From To
PSU2 / CAN1 CAN socket where terminator is situated (ter-
minator to be removed and replaced by the
cable instead). Could be on a filter or ATCC.
In case of no redundant Site Controller, the
terminator should be placed in PSU 2/ CAN 2
output.
303.
389.
6802800U74-AD | September 2014 |
Expansion Options | 381
PSU2 / AC In
PSU2 / Battery Temp. Sens.
PSU2 / DC Out
Additional Base Radio for
Send Feedback
Exhibit D2