Configuring An Ipv6 Over Ipv6 Tunnel; Configuration Prerequisites; Configuration Guidelines - HP 10500 Series Configuration Manual

Encapsulation is TUNNEL, service-loopback-group ID is 1.
Tunnel source 2002::0002:0001, destination 2002::0001:0001
Tunnel bandwidth 64 (kbps)
Tunnel protocol/transport IP/IPv6
last clearing of counters:
Last 300 seconds input:
Last 300 seconds output:
167 packets input,
0 input error
170 packets output,
0 output error
# Ping the IPv4 address of the peer interface VLAN-interface 100 from Switch A.
[RouterA] ping 30.1.3.1
PING 30.1.3.1: 56
Reply from 30.1.3.1: bytes=56 Sequence=1 ttl=255 time=46 ms
Reply from 30.1.3.1: bytes=56 Sequence=2 ttl=255 time=15 ms
Reply from 30.1.3.1: bytes=56 Sequence=3 ttl=255 time=16 ms
Reply from 30.1.3.1: bytes=56 Sequence=4 ttl=255 time=15 ms
Reply from 30.1.3.1: bytes=56 Sequence=5 ttl=255 time=16 ms
--- 30.1.3.1 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 15/21/46 ms

Configuring an IPv6 over IPv6 tunnel

Configuration prerequisites

Configure an IPv6 address for the interface (such as a VLAN interface or loopback interface) to be
configured as the source interface of the tunnel interface.

Configuration guidelines

Follow these guidelines when you configure an IPv6 over IPv6 tunnel:
Specify public addresses or interfaces as the source and destination addresses for the tunnel
•
interfaces.
If the two tunnel interfaces at the tunnel ends reside on different subnets, you must configure a static
•
route or dynamic routing at each tunnel end so that they can reach other over the tunnel.
• If the destination IPv6 network is not on the same subnet as the IPv6 address of the local tunnel
interface, you must configure a route destined for the destination IPv6 network through the tunnel
interface. You can configure a static route, and specify the local tunnel interface as the output
interface or specify the IPv6 address of the peer tunnel interface as the next hop. Alternatively, you
can enable a dynamic routing protocol on both tunnel interfaces to achieve the same purpose. For
the detailed configuration, see Layer 3—IP Routing Configuration Guide.
Never
1 bytes/sec, 0 packets/sec
1 bytes/sec, 0 packets/sec
10688 bytes
10880 bytes
data bytes, press CTRL_C to break
182