Device Range That Can Be Set - Mitsubishi Electric GOT2000 Series Connection Manual

12.6 Device Range that Can Be Set

The device ranges of controller that can be used for GOT are as follows.
Note that the device ranges in the following tables are the maximum values that can be set in GT Designer3.
The device specifications of controllers may differ depending on the models, even though belonging to the same series.
Please make the setting according to the specifications of the controller actually used.
When a non-existent device or a device number outside the range is set, other objects with correct device settings may not
be monitored.
■1. Setting item
Item
Device
Information
Network
*1
12 - 16
12.6 Device Range that Can Be Set
Set the device name, device number, and bit number.
The bit number can be set only when specifying the bit of word device.
Displays the device type and setting range which are selected in [Device].
Set the monitor target of the set device.
Monitors the PLC of the specified station No.
0 to 31:To monitor the PLC of the specified station No.
Station No.
100 to 115: To specify the station No. of the PLC to be monitored by the value of GOT data register (GD).
The following shows the relation between station numbers of the PLC and the GOT data register.
Station No.
100
101
:
114
115
POINT POINT POINT
Device settings of LS IS PLC
(1) When setting bit device (except timer and counter)
Set the bit device using the decimal number (three digits) and the hexadecimal number.
Device name
Description
GOT data register (GD)
GD10
GD11
:
GD24
GD25
Device number
HEX
DEC
Setting range
0 to 31
(If setting a value outside the range above,
a device range error occurs.)
*1