Panasonic KX-HDV130 Manual page 42

2.4 Configuration File Specifications
"VM_NUMBER_1": for line 1,
"VM_NUMBER_2": for line 2 (For KX-HDV130)
, ..., "VM_NUMBER_6": for line 6 (For KX-HDV230)
, ..., "VM_NUMBER_12": for line 12 (For KX-HDV330)
, ..., "VM_NUMBER_16": for line 16 (For KX-HDV430)
Note
•
The number of lines available varies depending on the phone being used, as follows:
–
KX-HDV130: 1–2
–
KX-HDV230: 1–6
–
KX-HDV330: 1–12
–
KX-HDV430: 1–16
•
Some parameter values can be specified as "empty" to set the parameter values to empty.
Example:
NTP_ADDR=""
•
The parameters have no order.
•
If the same parameter is specified in a configuration file more than once, the value specified first is
applied.
•
All configurable settings can be specified in the configuration file. You can ignore settings that already
have the desired values. Only change parameters as necessary.
•
Boolean parameters (BOOLEAN) accept all of the following configurations.
"Y": "Y", "y", "Yes", "YES", "yes"
"N": "N", "n", "No", "NO", "no"
Parameter Extensions
You can use parameter extensions to specify parameters as Read-Only or Carrier Default.
Read-Only Specification
•
When "?R" or "?r" is specified, the phone user interface and Web user interface for the parameter in
question is restricted to Read-Only.
* Restricting the phone user interface to Read-Only
The Read-Only parameter settings menu appears, but an error occurs during registration.
* Restricting the Web user interface to Read-Only
The Read-Only parameter settings menu appears grayed out and nothing can be entered.
Note
•
Parameters that can be configured from the device and from the Web can be confirmed from
footnotes 1-3 on the parameter names in "5.1 Configuration File Parameter List".
•
When "?R" or "?r" is not specified, the phone user interface and Web user interface are both readable
and writable.
* Optional specifications for "?R" and "?r" are enabled when the last parameter in question is configured.
Carrier Default Specification
•
When "?!" is specified, applicable parameter values are managed as carrier default values when applied
to operational information.
* Carrier default values are applied once a reset to carrier defaults is executed. Carrier defaults will also
be initialized when a reset to device defaults is executed.
42 Administrator Guide Document Version: 2017-07