Active Zones (When Arming) - GE Advisor MASTER ATS111 series Manager Manual

Active zones (when arming)

You cannot arm (or disarm, if your system is programmed that way) an area unless all the zones in that area
are normal, as an active zone would usually set off an alarm. For example, all the doors and windows must be
closed.
If a zone is active while you try to arm or disarm an area, the Advisor MASTER keypad sounds seven quick
beeps and displays the active zones.
Active zones are listed either:
One at a time
or
As a list of numbers
From either display:
Action
Press [NEXT]
Enter area number and press [ENTER]
Press [CLEAR]
After you have determined which zones are active, you must check these and correct the problem (for
example, close the door), then exit this display, and try again to arm. If you are unable to close the zone, refer
to Menu option 10, Inhibit Zone.
See also: Arming Your System on page 15; Disarming Your System on page 17; Inhibit Zone - Menu Option 10 on page 40.
Example: Active On 6. Front Door
NEXT or ENTER
Example: Active On 6, 7, 9.
Zone No:
Result
Update the list of active zones and display the next zones in the list (if any).
Display the zone name in full.
Exit the function and return to the display shown when you were
attempting to arm the system.
19