Table of Contents
Advertisement
[EA70] Stack exit belt home position error / Stack slider home position error
MJ-1101
1. Check if the connector CN11 on the finisher controller PC board is disconnected from the stack
belt exit home position sensor (S9) and the harnesses are open circuited. Correct if any.
2. Is the harness between the stack transport motor (M5) and the finisher control PC board (CN10)
disconnected or open circuited?
3. Replace the sensor.
4. Replace the finisher controller PC board.
MJ-1031
1. Check if the connector J111 on the finisher controller PC board is disconnected from the stack
edging HP sensor (SR8) or the harnesses are open circuited. Correct if any.
2. Check if the connector J111 on the finisher controller PC board is disconnected from the stack
slide motor (M4) or the harnesses are open circuited. Correct if any.
3. Replace the stack slider HP sensor.
4. Replace the stack slide motor.
5. Replace the finisher controller PC board.
e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C
ERROR CODE AND TROUBLESHOOTING
© 2008 - 2011 TOSHIBA TEC CORPORATION All rights reserved
6 - 46
Advertisement
Table of Contents
