3.1.8
Image dimensional adjustment at the printing section
The printer related adjustment is performed by using the printed out grid pattern.
Adjustment
Tolerance
A
200 ± 0.5mm
B
52 ± 0.5mm
C
200 ± 0.5mm
D
52 ± 0.5mm
E
52 ± 0.5mm
© 2008 - 2011 TOSHIBA TEC CORPORATION All rights reserved
1
6
B, E
Fig. 3-13
Refer to "[A] Reproduction ratio of primary scanning direction (Fine adjustment of
polygonal motor rotation speed (Printer))"
Refer to "[B] Primary scanning data laser writing start position (Printer)"
Refer to "[C] Reproduction ratio of secondary scanning direction (Fine adjustment
of transfer belt motor rotation speed (Printer))"
Refer to "[D] Secondary scanning data laser writing start position"
Refer to "[E] Primary scanning data laser writing start position at duplexing"
3 - 15
21
A
Detail of adjustment
e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C
3
ADJUSTMENT