Adjusting The Playback Picture; Changing Audio; Auto Bilingual Choice Function; Manual Tracking - Panasonic DMR-EH75V Operating Instructions Manual

The unit usually makes tracking adjustments, but you may need to
do it manually if noise appears on a tape recorded on other
equipment.
During play
Press [TRACKING/V-LOCK, -I-] or
[TRACKING/V-LOCK, -].
Repeat until the noise disappears.
Adjust the vertical synchronization to stop the picture from jiggling
while paused.
This works only while VHS is paused during recording on the DVD.
While paused
Press [TRACKING/V-LOCK, -t-] or
[TRACKING/V-LOCK, -].
Repeat until the jiggling stops.
• To return to auto tracking
Press both [TRACKINGN-LOCK, +] and [TRACKINGN-LOCK, --]
simultaneously.
• To remove the noise from a paused picture
Start slow play, then adjust the tracking.
Note
oThis function may not work with some TV models and tapes.
• You can also adjust the tracking and vertical synchronization with
[CH, A, v] on the main unit.
While playing tapes
Press [AUDIO].
The audio changes as follows:
Stereo _ Mono L _ Mono R _ No display (Normal audio track)
" I
When a stereo broadcast or SAP broadcast is recorded and played
back on the unit, stereo sound will be automatically selected in the
case of a stereo broadcast and SAP sound will be automatically
selected in the case of a dual-sound broadcast (Mono and SAP or
Stereo and SAP).
oThis function may not work properly if the program is played back
from a mid point. In a case like this, press [AUDIO] and select the
right sound.
oThe function will not work with a cassette which has been recorded
using external equipment.
It is also possible to play back tapes recorded in the S-VHS system.
• Some picture noise may occur depending on the type of tape used.
olt is not possible to fully obtain the high resolution that S-VHS is
capable of.
olt is not possible to record in the S-VHS system with the unit.
The unit automatically records special index signals on the tape
every time a recording is started. The index search function makes
use of these index signals to let you find the beginning of a desired
program quickly and easily.
• Index signals are recorded in the following cases.
• When a recording is started by pressing [O, REC].
Preparation
olnsert a recorded video cassette. (4 12)
While stopped or during normal play
Press
[ _ ] or [ _ ].
oEach press increases the number of skips.
• To cancel the index search
Press [i, STOP].
Note
• Up to 20 index signals can be searched for in both directions.
• If you press either one of the buttons too much, you can control the
number of skips by pressing the opposite button.
oThe figure on the display decreases by 1 each time an index signal
is located.
oThis feature may not work correctly if the index signals are too
close together. Make recordings of at least 5 minutes.
RQT8346