Sony KDE-P37XS1 Operating Instructions Manual page 58

Problem
The picture is too bright.
Picture (stripe) noise.
Poor picture (white saturation) when
viewing a signal from Scart connector
3/ .
S
Stripe noise during playback/recording
of a VCR.
Poor or no picture (screen is dark), but
good sound.
Noisy picture when viewing a TV
channel.
Distorted picture when changing
programmes or selecting teletext.
In the screen appears an image retention
(afterimage).
The screen flickers when turning on the
TV.
No sound/Noisy sound
Good picture, no sound.
Audio noise.
58
Additional Information
Possible solution
• Using the menu system, select the "Picture Adjustment" menu and
select "Picture Mode" Then select the desired picture mode (page
22).
• Make sure that the aerial is connected using the supplied coaxial
cable.
• Keep the aerial cable away from other connecting cords.
• Do not use 300-ohm twin lead cables as interference may occur.
• Make sure that the output signal of the equipment connected to the
Scart connector 3/
signal, please connect the equipment to Scart
2/ .
• Video head interference. Keep your VCR away from the TV.
• Leave a space of 30 cm between your VCR and the TV set to avoid
noise.
• Avoid installing your VCR in front or at the side of the TV set.
• Using the menu system, select the "Picture Adjustment" menu and
select "Reset" to return to the factory settings (page 23).
• If the PICTURE OFF indicator lights up in blue, press
(picture off) on the remote control.
• Using the menu system, select the "Manual Programme Preset"
option in the "Set Up" menu and adjust Fine Tuning (AFT) to
obtain better picture reception (page 32).
• Using the menu system, set the "Noise Reduction" option in the
"Picture Adjustment" menu to reduce the noise in the picture (page
23).
• Turn off any equipment connected to the Scart connector on the rear
of the TV set.
• Using the menu system, select the "Features" menu, next select the
"Screen Saver" submenu and finally set the "All White" option to
"On" to reduce the image retention (see page 28).
• This is inherent in the Plasma Display Panel, and does not indicate
a malfunction.
• Press the 2 + on the remote control.
• Check that "TV Speakers" option is set to "Main" in the "Sound
Adjustment" menu (page 25).
• Make sure that the aerial is connected using the supplied coaxial
cable.
• Keep the aerial cable away from other connecting cords.
• Do not use 300-ohm twin lead cables as interference may occur.
• Communication problems may occur if the infrared communication
equipment (e.g. infrared cordless headphones) is used near the TV.
Please use headphones other than infrared cordless headphones,
move the infrared transceiver away from the TV until the noise is
eliminated, or move the transmitter and receiver of the infrared
communication equipment closer together.
is not an RGB signal. If it is an RGB
S
1/ or
continued...