Jog Operating Mode - Siemens SINUMERIK 840D Operator's Manual

5
03.04
 Siemens AG, 2004. All rights reserved.
SINUMERIK 840D/840Di/810D Operator's Guide Handheld Terminal 6 (BAH) - 03.04 Edition
If you change into this area later on then the above working window is
not necessarily displayed, as the last selected working window pops
up instead.
Caution
When the system is switched on, the actual value display will not
correspond to the actual positions of the axes.
You should therefore ignore the actual value display until the axes
have been referenced.
WCS Actual Values working window
The first six axes in the WCS coordinate system are visible. It is
possible to scroll up and down if there are more than six axes.
The names of the axes are defined by the machine manufacturer in
the machine data.
• St (status) and Tu (turn) indicate the position of the axis and the
sign of the axis rotation, both as 8-bit information.
They only appear
- in the status "WCS actual values" and
- if PTP (point-to-point) traversing is supported by the NC.
• Increment only appears when incremental traversing is active.
• Automatic and Mda operating modes:
- The distance-to-go is displayed instead of the repos.
displacement (provided the selected machine function is not
Reposition).
- The recall sign ^ appears in the dialog line on the left.
- The symbol
positioning mode").
Manual Mode – Operating Area Machine

5.2 Jog operating mode

appears at the top left ("all axes in exact
5
5-61