GE CV936 Owner's Manual And Installation Instructions page 17

Installation Instructions
[] iNSTALL MOTOR
* Align and engage the
slots in the blower
assembly to the 3 hooks
at the rear of the
exhaust opening.
until it aligns Mth the ....
attachlnent screw#
location.
.Secm'etheinotorto _%__ ____
attachment bracket
at the front of the i...........................
opening with wash er
and screw prox ided.
* Plug the motor connector into
the mating hood connectm: See
the illustration fbr the hood
connector location. Touch the
hood to locate and make the
collnectJon.
IMPORTANT: Hold the
conllector so the two sq
corner terlllillals are at
the top as you
position the connector to plug it in.
_8_CONNECT ELECTRICAL
Verify that power is turned off at the source.
WARNING: ifhouse wh-h g is not 2-wh'e
with a gromM wire, a gromM must be provided by the
installer. When house wiring is aluminmn, be sure to
use L I.I,. approved anti-oxidant compound and
a] HIll i n HI//-to-copp er COllnectors.
A Remove C Insert Power
Junction Box Conduit Thru
Cover Strain Relief
i \ White
round--_.1 , 1 B,ock
B Check That White, Blackand I'_ff _ I
Green Hood Wires Are Threaded I I_[ "q_ _ I
Thru Small Hole in Bracket _ j
[_ Use UL Listed Wire Nuts
* Use wire nuts to connect incoming gr(mnd to green,
white to white and black to black,
* Push wires intojm*ction box and replace cover.
Be sure wires are not pinched.
I9] INSTALL DUCT COVERS
To install the 12 "duct cover alone:
* Place the 12" section of the decorative duct cover on
top of the hood.
* Secure the cover to the top of the hood with 4 screws
provided.
To install the 2-piece duct cover:
* Place the 2-piece duct cover on top of tile hood.
o Secure the bottom co\ er to the top of the hood with
4 screws provided. See illustration, page 16.
o Extend the inside section upwards to meet the
ceiling and ceiling bracket.
* Secm'e the duct cover to the bracket with the 2 small
Phillips
screws provided.
INSTALL FILTER SUPPORT
* Tip filter support into the rear of the hood.
* Insert support tabs into the slots at the rear of
the hood.
Insert Tabs Into Slots
Install 2 Screws
* Secure the support to the hood with screws as shown.
17