Pioneer DDJ-SX2 Service Manual page 26

1
A Table-3 LED behavior of when rotary encoders, slide SWs, and Jog dials are checked
Group Trigger
G Slide Lighting position of white LEDs of Jog dial of the same side is moved clockwise whenever position of the slide SW is
moved. Refer to Figure-4.
H H1 Press LED lighting is changed as shown in following order whenever the Rotary selector is pressed.
Even if the Rotary selector is released while the LEDs are lit, the controller holds lighting.
All LEDs are lit with full brightness. (LED color of the Pad Mode buttons and Pads is white.) ⇒
All LEDs are lit with full brightness. (LED color of the Pad Mode buttons and Pads is red.) ⇒
All LEDs are lit with full brightness. (LED color of the Pad Mode buttons and Pads is yellow.) ⇒
All LEDs are lit with full brightness. (LED color of the Pad Mode buttons and Pads is green.) ⇒
All LEDs are lit with full brightness. (LED color of the Pad Mode buttons and Pads is cyan.) ⇒
All LEDs are lit with full brightness. (LED color of the Pad Mode buttons and Pads is blue.) ⇒
All LEDs are lit with full brightness. (LED color of the Pad Mode buttons and Pads is magenta.) ⇒
B
All LEDs are lit dimly. (LED color of the Pad Mode buttons and Pads is white.) ⇒
All LEDs are lit dimly. (LED color of the Pad Mode buttons and Pads is red.) ⇒
All LEDs are lit dimly. (LED color of the Pad Mode buttons and Pads is yellow.) ⇒
All LEDs are lit dimly. (LED color of the Pad Mode buttons and Pads is green.) ⇒
All LEDs are lit dimly. (LED color of the Pad Mode buttons and Pads is cyan.) ⇒
All LEDs are lit dimly. (LED color of the Pad Mode buttons and Pads is blue.) ⇒
All LEDs are lit dimly. (LED color of the Pad Mode buttons and Pads is magenta.) ⇒
All LEDs are unlit.
Turn Lighting position of white LEDs of both side Jog dials are moved whenever the Rotary selector is turned.
Refer to Figure-4.
H2 Press LED within the TAP button of the same side is lit while the rotary encoder is pressed and held.
When the rotary encoder is released, the LED is unlit.
C
Turn Lighting position of white LEDs of Jog dial of the same side is moved whenever the rotary encoder is turned.
Refer to Figure-4.
I Touch All white and red LEDs of Jog dial are lit while top surface of the Jog dial is touched and held.
When top surface of the JOG is released, the LEDs are unlit.
Turn Lighting position of white LEDs of Jog dial is moved when the Jog dial is turned.
Refer to Figure-4.
Figure-4 LED behavior of when a slide SW is slid, a rotary encoder is turned, or a Jog dial is turned
*: Only when positon of a slide SW is moved, lighting position of white LED is moved clockwise.
*: The starting position depends on the last position.
D
E
F
26
1
2
Details
DDJ-SX2
2
3
3
4
4