Display Data And Transmission Data; Fault Details Monitor (Dt 140 To 143) - Panasonic AAD03011 Instruction Manual

Display data and transmission data

For the data for monitoring or setting, the display data of the inverter may differ from
the transmission data, so transmission data should be used as the data to be used
for communication.
Calculate the transmission data using the following table of the data type.
Data type
1
2
3
4
5
6
7
8

Fault details monitor (DT 140 to 143)

Data of fault details is as below.
Data
Overcurrent/Over
0 2
temperature
3 5 Overcurrent
6 8 Overvoltage
80
Relationship between display data and transmission data
Displayed data and transmission data is the same.
(Transmission data) = (Display data)
Data in 0.1 unit
(Transmission data) = (Display data) 10
Data in 0.01 unit
(Transmission data) = (Display data) 100
Parameter P03 (V/F pattern) data
Display data : 50 60 FF
Transmission data : 0 1
Parameter P13 (DC brake level) data
(Transmission data) = (Display data) /5
Parameter P34 (carrier frequency) data
Display data
Transmission data : 0
Parameter P36 (communication speed) data
Display data
Transmission data : 4
Parameter P51 (No. of motor poles) data
(Transmission data) = (Display data) /2
Fault details
2
: 0.8 1.1 1.6 2.5 5.0 7.5 10.0 12.5 15.0
1 2 3
: 48 96 192
5 6
Data
9
10
1
5
8
9
0
10
4 5 6 7
Fault details
Undervoltage
Overload
Auxiliary fault
Operation error
Encoder fault(No pulse)
Encoder fault (anti-detection)
Arrival signal is turned ON on two sides
No OPEN arrival signal
No CLOSE arrival signal
8