Hitachi wj200 series Quick Reference Manual page 85

Option Terminal
Code Symbol
21
ZS Zero Hz Speed
Detection Signal
22
DSE Speed Deviation
Excessive
23
POK Positioning Completion
24
FA4 Frequency Arrival Type
4–Over frequency
25
FA5 Frequency Arrival Type
5–Set frequency
26
OL2 Overload Advance
Notice Signal 2
27
ODc Analog Voltage Input
Disconnect Detection
28
OIDc Analog Current input
Disconnect Detection
31
FBV PID Second Stage
Output
32
NDc Network Disconnect
Detection
33
LOG1 Logic Output Function 1
34
LOG2 Logic Output Function 2
35
LOG3 Logic Output Function 3
39
WAC Capacitor Life Warning
Signal
Output Function Summary Table
Function Name
ON Output frequency falls below the threshold
specified in C063
OFF Output frequency is higher than the threshold
specified in C063
ON Deviation of speed command and actual speed
exceeds the specified value P027.
OFF Deviation of speed command and actual speed
does not exceed the specified value P027.
ON Positioning is completed
OFF Positioning is not completed
ON When output to motor is at or above the set freq.,
even if in accel (C045) or decel (C046) ramps
OFF When output to motor is OFF, or at a level below
the set frequency
ON When output to motor is at the set frequency,
during accel (C045) and decel (C046).
OFF When output to motor is OFF, or is not at a level of
the set frequency
ON When output current is more than the set
threshold (C111) for the overload signal
OFF When output current is less than the set threshold
for the deviation signal
When the [O] input value < B070 setting (signal
ON
loss detected)
OFF When no signal loss is detected
When the [OI] input value < B071 setting (signal
ON
loss detected)
OFF When no signal loss is detected
ON Transitions to ON when the inverter is in RUN
Mode and the PID Process Variable (PV) is less
than the Feedback Low Limit (C053)
OFF Transitions to OFF when the PID Process Variable
(PV) exceeds the PID High Limit (C052), and
transitions to OFF when the inverter goes from
Run Mode to Stop Mode
ON When the communications watchdog timer (period
specified by C077) has time out
OFF When the communications watchdog timer is
satisfied by regular communications activity
When the Boolean operation specified by C143
ON
has a logical "1" result
When the Boolean operation specified by C143
OFF
has a logical "0" result
When the Boolean operation specified by C146
ON
has a logical "1" result
When the Boolean operation specified by C146
OFF
has a logical "0" result
When the Boolean operation specified by C149
ON
has a logical "1" result
When the Boolean operation specified by C149
OFF
has a logical "0" result
ON Lifetime of internal capacitor has expired.
OFF Lifetime of internal capacitor has not expired.
85
Description