Samsung OfficeServ 7000 Series Programming Manual page 63

No Feature
14 NOT CONT.CID
15 AUTO ANS CO
16 ENBLOCK 2LCD
17 STN NO RING
18 FEATURE TONE
19 RCV GPU INFO
20 MISSED CALL
21 NO DISP TRK#
D EFAULT DATA
3 1 0 B
SEE DESCRIPTION
SOME OPTIONS DEPEND ON COUNTRY
Samsung Business Communications
Default
ON When OFF, the Caller ID will be displayed for the dura-
tion of the call. When ON, displays timer for duration of
call (if AUTO TIMER also set on).
OFF When ON, keyset will automatically answer outside calls
through the speakerphone. For this to work, the keyset
must be set to Auto Answer mode in MMC 103. Calls to
groups cannot be auto-answered.
OFF Enables Enbloc dialling for 2-Line LCD phones. This op-
tion only works when 2 LINE ENBLOCK option is en-
abled in MMC 861.
OFF When ON, no tones will be heard when phone rings.
OFF When the extension is set as 'ON' and a subscriber sets
the extension function, a tone (message tone) different
from dial tone will be heard. The relevant functions are
DND, All Forward, Busy Forward, No Answer Forward,
Follow Me and Station Lock functions.
OFF When ON, the extensions will receive the information of
PING RING. This function can operate in case PING
RING SERVICE is enabled in MMC861.
OFF When ON, the information of the missed calls will be dis-
played on extensions. The missed call means that the
ringing call is not answered. The information of the
missed calls includes the below
- The call which was not answered.
- In case the call which was occurred by group
call was not answered.
- In case the call by group call was overflowed to
the other extension.
- The call which was forwarded because of set-
ting NO ANSWER FORWARD
- The call which was picked up by other exten-
sions
- In case of Call Waiting, it is not included.
OFF This feature selects whether the trunk number is dis-
played or not for the duration of the call. When ON, in-
coming or outgoing number without trunk number will be
displayed. If there is no incoming/outgoing number to be
displayed, only trunk number will be shown.
CHAPTER 2. MMC Programming
(continued)
Description
2-21