Digital Input Configuration - ABB ScreenMaster RVG200 Operating Instructions Manual

ScreenMaster RVG200
Paperless recorder

7.9.3 Digital input configuration

Note. The Digital I/P tab is displayed only if Source ID for the Recording Channel is set to a digital
signal source – see Section 7.9.1, page 86.
Digital I/P A1
Input type *
Digital on tag
Digital off tag
Tag
* If this parameter is changed to or from Volt-free Digital Input or 24V Digital Input, internally-recorded data
files are recreated and unarchived data is lost.
94
Note. This parameter is displayed only if Input type on the Analog I/P
tab (see page 90) is set to Volt-free Digital Input or 24V Digital Input. If this
parameter is changed to anything other than Volt-free Digital Input or 24V
Digital Input, the input channel reverts to an analog input channel – see
page 90.
Enter the tag to be displayed on channel indicators when the digital signal
is active (6 characters maximum).
Refer to Appendix F, page 180 for further information regarding character
use in tags.
Enter the tag to be displayed on channel indicators when the digital signal
is inactive (6 characters maximum).
Refer to Appendix F, page 180 for further information regarding character
use in tags.
Enter the tag name to be displayed in the Chart-, Bargraph- and
Indicator-views and used to identify the channel in archive files
(16 characters maximum).
Refer to Appendix F, page 180 for further information regarding character
use in tags.
7 Configuration
OI/RVG200-EN