Hybrid Modules - ABB ScreenMaster RVG200 Operating Instructions Manual

ScreenMaster RVG200
Paperless recorder

7.10.3 Hybrid modules

Output C1(to D6)
Output Mode
Note. The following parameter is displayed only if Output Mode is set to Analog or Digital.
Source
Note. The following parameters are displayed only if Output Mode is set to Analog.
Engineering low
Engineering high
Electrical low
Electrical high
Note. The following parameter is displayed only if Output Mode is set to Digital.
Polarity
OI/RVG200-EN
Select the output mode required – Analog, Digital or TxPSU.
Select the output source required.
An analog output source is the internal analog signal used to generate the
analog output signal.
A digital output source is the internal digital source used to activate /
de-activate a digital output.
Note. If a digital output is used to provide a totalizer count pulse, the
maximum pulse frequency is 1 Hz.
Set the required analog output engineering range.
Note. These settings are the engineering values corresponding to the
and
Electrical low Electrical high
Set the required analog output electrical range.
These values are the minimum and maximum values of the current output,
in electrical units – range 0 to 23 mA.
Source range high
Analog output
engineering high
Analog output
engineering low
Source range low
Select the digital output source polarity.
Note. When set to Positive, the digital output is energized when the
digital source is active (On).
values below.
Analog output
electrical high
Analog output
electrical low
7 Configuration
115