Yamaha CL1 Reference Manual page 8

■ GAIN/PATCH field
This field enables you to make HA (head amp) analog gain settings, and view the operational status of
the head amp.
1
GAIN knob
Sets the analog gain of the head amp.
For a channel to which the head amp has not been
patched, a gray circle appears, instead of the knob. Press
the knob to open the GAIN/PATCH 1ch popup window.
If the Gain Compensation function is turned on, an
indicator appears, showing the level of the signal output
to the audio network.
2
OVER indicator
Warns you when the signal is clipping.
3
+48V indicator
Indicates the phantom power on or off status for the head amp.
4
Ø (Phase) indicator
Indicates the input phase setting for the head amp.
NOTE
• For an input channel that is patched to an input that has no head amp,
3
and will not be shown. For an output channel,
shown.
• If GAIN KNOB FUNCTION is set to DIGITAL GAIN in the USER SETUP → PREFERENCE
screen, the digital gain knob will appear for
For details, refer to "Making HA (Head Amp)
■ PAN/BALANCE field
This field enables you to switch the on/off status of the signal sent from the selected channel to the
STEREO/MONO bus, and adjust the pan and balance.
The view and the function of the controllers in this field vary depending on the type of the selected
channel.
When an input channel or MIX channel is selected:
1
TO STEREO PAN knob
Sets the pan position of a signal routed to the STEREO
bus.
Press the knob to open the STEREO/MONO 8ch popup
window. If the ST IN channel is selected, you can specify
whether to view the PAN knob or the BALANCE knob in
this popup window. For a MIX channel, the PAN knob
will appear if the signal is mono, and the BALANCE
knob will appear if the signal is stereo.
2
1
3 4
1
will be a gray circle
1 2 4
will be a gray circle, and – will not be
1 3
, and will not be displayed.
settings" on page 30.
1
2
ST/MONO button
Switches the on/off status of a signal sent from the
channel to the STEREO/MONO bus.
If an INPUT/MIX channel is set to LCR mode, the LCR
button appears in location
The LCR button is an overall on/off switch for the signals
sent from the channel to the STEREO/MONO bus.
When a MATRIX, STEREO, or MONO channel is selected:
1
BALANCE knob
If the signal on the selected channel is stereo, the
BALANCE knob will appear, enabling you to adjust the
volume balance for the left and right channels. If the
channel signal is monaural, a gray circle will appear in
this location.
Press the knob to open the TO STEREO 8ch popup
window.
■ INPUT DELAY field
This field enables you to view the delay settings.
1
ON indicator
Indicates the on/off status of the delay. If the delay is off,
the indicator will not be displayed.
2
Delay time
The delay value is displayed by milliseconds (ms) and also by currently-selected scale. If the scale
uses units of ms, the value in the bottom row will not be displayed. Only the ms value appears in
the middle row.
Press this field to open the INPUT DELAY 8ch popup window.
■ HPF field (input channels only)
This field enables you to set the HPF.
1
HPF knob
Sets the HPF cutoff frequency.
2
ON button
Switches the HPF on or off.
2
If an output channel is selected, a gray circle will appear in location
8
2
.
1
1
2
1
1
, and button
SELECTED CHANNEL section
2
2
2
will be hidden.
Reference Manual