Canon ae1 Installation Procedures Manual page 36

3.4
Operation Check
3.4.1 Operation Check
After installation, turn on the host machine and check
the paper feed and stapler operation.
3.4.2 Resetting the Parts Counter
After verifying normal operation, select the following
menu in the service mode to reset the parts counter.
Service mode > COPIER > COUNTER > DRBL-2
[Resetting a parts counter]
SORT
FrN-STPR
SADDLE
SDL-STPL
Pressing the clear key will reset the desired counter.
4.1
Installation Procedure
(When Installing the
Puncher Unit after Having
Installed the Finisher)
4.1 .I Unpacking the Puncher Unit
MEMO:
The machine is fitted with tape and cushioning ma-
terial to protect against vibration and shock during
transit. Be sure to remove all of it as instructed be-
fore the installation work. It is a good idea to store
away the removed tape and cushioning material for
possible future relocation and shipment for repairs.
1) Remove the attachments and the puncher unit from
the shipping box.
2) Remove the tape from the outside of the puncher
unit.
3) Open the punch upper cover.
4) Remove the two fixing screws [I] each, and detach
the front and rear punch fixing plates [ 2 ] .