Sony DWZ-M50 Operating Instructions Manual page 13

For details on the cable tone generator, see
"Configuring the cable tone generator" (page 22).
g CHANNEL (channel selection)
switch
Turn the knob to select the receiving
channel.
The receiving channel will be set to the
channel of the RF mode that is selected with
the RF MODE switch. The factory default
setting is 1/a.
For details on settings, see "Configuring the RF
mode and receiving channel" (page 21).
h RF MODE indicators
The indicator of the RF mode that is
selected with the RF MODE switch lights.
i RF MODE (RF mode selection)
switch
Selects the RF mode. The factory default
setting is WIDE.
For details on settings, see "Configuring the RF
mode and receiving channel" (page 21).
j BALANCED OUTPUT connector
(XLR type)
Connect a mixer or similar device here.
For details on connections, see "System
Configuration Examples" (page 27).
k Cable clamp attachment hole
Attach the supplied cable clamp here.
For details on attaching the cable clamp, see
"Attaching the cable clamp" (page 17).
l DC IN 9V (power input) connector
Use this to connect to a commercially
available 9 V DC power supply unit.
m DC IN 12V (power input) connector
Connect the supplied AC adapter here.
n POWER switch
Turns the unit on or off.
o TX MUTING (transmitter muting)
indicator
Indicates the status of the muting function
for the transmitter.
This blinks orange when the muting
function is enabled.
p TX BATT (remaining transmitter
battery) indicator
Indicates the remaining battery charge of
the transmitter.
Indicator Status
Lit (green) Good
Lit (red) Almost dead
The remaining battery indication only
appears when alkaline dry cell batteries are
being used.
Bottom
a Battery compartment
Insert a square 9 V dry cell (6LR61) battery
here.
For details on how to insert batteries, see "Inserting
Batteries" (page 14).
Parts Identification 13