Table of Contents
Advertisement
25. The Select LD Binding Parameters window
allows you to create and bind logical disks to
application servers.
The following options are available when binding
logical disks from the wizard:
Bind/Select – Configure and select a pool to
be bound to logical disks in the the Bind Pool
and Bind Select window.
LD Capacity – Set the capacity of the logical
disks.
Number of LDs – Set the number of logical
disks to create.
LD Name Prefix – Add a prefix name to the
logical disk.
Quick Format – Perform a quick format of
any logical disks created.
GPT Disk Type – Enable GPT type if a
volume is larger than 2 TB.
Create Hot Spare – Assign a physical disk
as a hot spare drive for the logical disk.
(Recommended)
When all settings are correct, click Next
to continue.
Note: If you change the Number of LDs, the LD Capacity needs to be manually changed.
11. At the Setup Details window, review and confirm
that the configuration settings are correct, and
then click Next to continue.
NEC D3-10i Quick Start Guide
57
Advertisement
Table of Contents
