Table of Contents
Advertisement
STEP 1: Planning and Preparation
This section describes the planning and preparation steps that need to occur before you install the array.
Preparing For Installation
Before installing the array, the following steps should be performed on the application servers that will be
connected to the array:
1. Install any additional gigabit Ethernet NICs on all application servers as needed for iSCSI connectivity.
2. Install and apply the latest driver updates for all application server NICs that will be used for iSCSI
connectivity.
3. Ensure that the array and application servers will reside on the same network subnet and all necessary
IP addresses have been reserved for each iSCSI port that will be connected to that network.
4. Optional: Install and configure at least one iSCSI Naming Services (iSNS) Server on the same network
segment as the array and the application servers that will connect to the array.
5. If a specialized iSCSI HBA will be used instead of a software iSCSI initiator, ensure that all iSCSI
adapters and iSCSI switches, if used, are installed and configured on all application servers as
specified by the hardware vendor.
Note: Check with your D3-10i sales representative to get the latest information about iSCSI HBAs that
have been certified for use with the D3-10i array.
Unpacking the Array
While unpacking instructions are illustrated on the array packaging materials, the following tips should be kept
in mind when unpacking the base unit.
To prevent component damage caused by condensation due to rapid temperature and humidity
changes, please allow the base unit to sufficiently acclimate to the ambient room temperature before
unpacking.
To prevent injury, the array should be unpacked, lifted out of the packing materials, and moved by at
least two people.
To prevent damage to the base unit, the unit should be held by the bottom of the unit when removed
from the packing material or moved. It is not recommended to lift or carry the unit by holding on to
projecting surfaces such as the power supply units or plastic bezel mounts.
Please save all packing materials in case the unit needs to be returned for repairs or shipped to other
locations.
Record the array serial number and model number located on the back of the array or inside the
cabinet door of the array, then visit
registration information in order to receive an additional 30 days of warranty coverage.
NEC D3-10i Quick Start Guide
http://www.necam.com/registration
to fill in your self-support
3
Advertisement
Table of Contents
