Sony BVM-X300 Operating Instructions Manual page 22

Submenu Setting
[Screen Saver] Sets the screen saver function [On] or
[Off].


Note
In the HDR display, this setting is
forcibly set to [On].
For details on the HDR (High Dynamic
Range) display, see page 23.
[Power On Setting] Sets this unit's setting status after the
unit is turned on. Select from [Last
Memory], [User Preset1], [User
Preset2], [User Preset3], [User Preset4],
[User Preset5] or [User Preset XYZ].
[User Reset] Returns to the factory default setting
except for the following:









[Input Setting]
22
Adjustment Using the Menus
[On]: If a still image is displayed for
more than 10 minutes, the
brightness of the screen is
automatically decreased to
reduce burn-in. The screen
returns to normal brightness
when you input a video signal to
the unit or operate the buttons
on the front panel of the unit.
While the screen saver is active,
the STATUS indicator flashes
every two seconds. Before the
screen saver starts up, the
STATUS indicator flashes every
second to notify users that the
screen saver will start up.
[Off]: The screen saver function is
deactivated.
Color temperature for [User1]
Color temperature for [User2]
Color temperature for [User3]
Color temperature for [User4]
Color temperature for [User5]
User Preset for [User Preset1]
Password setting
[Cancel]: Cancels reset.
[Confirm]: Resets the unit. When
reset finishes, this unit restarts.
[SDI 4K/UHD Input Setting]
Submenu Setting
[Input Setting] Sets the input setting of the SDI 4K
signal.
[Input Setting1]

[Input Setting2]

[Input Setting3]

[Input Setting4]

[Input] Set the input connector of the SDI 4K
signal.
[Input1,2,3&4]: Select to use SDI IN

[Input1&2]: Select to use SDI IN 

[Input3&4]: Select to use SDI IN 

[Interface Format] Displays the interface format of the 4K
input.
[Quad-Link 3G/HD-SDI]

[Dual-Link 3G-SDI]

[Image Division] Set the image division of the 4K input.
[Auto]: Select for the Auto setting.

[2SI]: Select to receive images of the 2

[Square]: Select to receive images of

[Signal Format] Select from the following when
[Interface Format] is [Quad-Link 3G/
HD-SDI].
[Auto]

[422 YCbCr 10bit]

[444 RGB 10bit]

[444 YCbCr 10bit]

[444 RGB 12bit]

[444 YCbCr 12bit]

[444 XYZ 12bit]

[422 YCbCr 10bit] is set when
[Interface Format] is [Dual-Link 3G-
SDI].
, SDI IN , SDI IN , and
SDI IN  with Quad Link.
and SDI IN  with Dual Link.
and SDI IN  with Dual Link.
sample Interleave system.
the Square system.